Sikagard 200 | Enviroseal Master Protect H 200 | 20% SILANE PENETRATING SEALER 5 Gallon

Product:

MasterProtect H 200 54G Drum (51672656). Clear, water-based, 20% silane penetrating sealer / water repellant. For stucco, concrete, brick and masonry. Price/Drum. (5G size shown in photo)

Ordering Notes:

Description:

Enviroseal 20 is a clear, water-based, 20% silane (alkylalkoxysilane) penetrating sealer.

FEATURES:

• Water based, VOC compliant (except S. Calif SCAQMD)
• Excellent penetration
• Moisture repellant
• Breathable
• Transparent, non-staining
• One component
• USDA Compliant for non-food contact areas (floors, food manufacturing and service structures)
• Provides long-lasting protection against moisture  and chloride intrusion
• Ideal for horizontal or vertical grade / non traffic-bearing surfaces, USDA compliant (non- food contact areas)

Yield (typical):

• Concrete: 100 – 175 ft2/gal (2.4 – 4.3 m2/L)
• Brick: 100 – 175 ft2/gal (2.4 – 4.3 m2/L)
• Stucco: 50 – 100 ft2/gal (1.5 – 2.4 m2/L)
• Always apply a test area to determine actual coverage rates. Coverage rates will vary greatly with the porosity of the substrate

APPLICATIONS:

• Concrete: architectural, exposed aggregate, glass reinforced, precast, cast in place, silica furne.
• Hard Burnt Brick.
• Stucco: troweled / smooth, integrally colored.
• Brick Pavers.
• Unglazed Tiles.

LOCATION:

• Vertical or horizontal
• Exterior or interior
• Above grade

How to Apply:

• Verify substrate has properly cured. Concrete should obtain 80% of design strength, typically achieved within 14 – 28 days.
• Clean concrete surfaces of all sand, surface dust and dirt, oil, grease, chemical films and coatings and other contaminants prior to application. Use waterblast, sandblast, or shotblast as necessary to achieve the desired surface condition.
• Surface, air, and material temperatures should be 40 to 110° F (4 to 43° C) during application. Do not apply Enviroseal 20 when temperatures are expected to fall below 40° F (4° C) within 12 hours.
• Surfaces to be treated can be slightly damp; however, a dry surface is suggested for maximum penetration of sealer. Do not apply Enviroseal 20 if standing water is visible on the surface to be treated.
• Crack control, caulking, patching, and expansion joint sealants can be installed before or after application of the sealer.
• Allow a minimum of 6 – 12 hours curing time for caulking and sealant materials (or until they have skinned over) before applying Enviroseal 20.

OPTIONS:

• Enviroseal 40(40% silane) for horizontal / traffic areas and where greater waterproofing is needed.
• Enviroseal 7 for hard-burnt vertical brick and other dense surfaces.
• Envirseal PBT for very porous vertical surfaces, such as split face block and lightweight concrete.
• Also available in 54 gallon drums from stock.